[Anthill-pro] Doing a clean build

[Jason Schatz]

Dan,

Anthill3 will not attempt to remove any files unless you have a cleanup
step in your job configuration.  If you are using a build job you will
need to make sure you have selected the cleanup option on the build job
configuration page.  If you are using a generic job configuration you
will need to make sure that you have a Perforce Cleanup Step running and
if you have selected the Delete Workspace Files option in your source
configuration this will remove all of the files and should give you the
behavior you are looking for.

Thanks,
Jason

Daniel Kirsch wrote:
>
> Hello, I am now having a clean build issue.  We are using Perforce and
> AnthillPro and it seems that I am unable to clean the build directory
> properly. 
>
>  
>
> I have created the Repository for Perforce and, in my project’s Source
> Config, I have also selected the Delete Workspace Files option.  I am
> able to check out the files and it builds fine.  However, nothing
> seems to happen on a second build to clean up the source.
>
>  
>
> Am I expecting it do something it does not do?
>
>  
>
> Regards,
>
>  
>
> Dan
>
>  
>
>  
>
> *Daniel Kirsch*
>
> /Principal Software Development Engineer/
>
> Ardence, a Citrix Company – www.ardence.com <http://www.ardence.com/>
>
> 266 2^nd Avenue
>
> Waltham, MA 02451
>
> 781.693.6326 Office
>
> 781.647.3999 Fax
>
> daniel.kirsch at citrix.com <mailto:daniel.kirsch at citrix.com>
>
>  
>
> ------------------------------------------------------------------------
>
> _______________________________________________
> Anthill-pro mailing list
> Anthill-pro at lists.urbancode.com
> http://lists.urbancode.com/mailman/listinfo/anthill-pro
>